Step by Step How to Make an In-the_hoop Coaster with Cork Fabric

FABRIC REQUIREMENTS::
Front: Cut 1 - 4.5” x 4.5” (12 cm x 12 cm)
Back: Cut 1 - 4.5” x 4.5” (12 cm x 12 cm)
(.4mm cork fabric was used for the samples)

INSTRUCTIONS:
1. Hoop washaway stabilizer in the hoop. We used 1 layer in the sample.
2. Load design into your machine using the correct format.
3. Stitch the placement line and remove hoop from the machine.
4. Place the front fabric in the hoop, covering the placement line. We used 505
spray glue, sprayed lightly on the back of the cork to hold it temporarily in place.
(use your preferred method of tape or pins instead if you wish)
5. Stitch the tackdown stitch to hold the fabric in place. Remove tape or pins if
necessary